 Jouni Malinen
|
64dbe6a78d
tests: Prepare rrm_beacon_req_passive_no_match_oom for code change
|
8 years ago |
|
Jouni Malinen
|
f2058f4afa
RRM: Remove unnecessary cb check
|
8 years ago |
 Dedy Lansky
|
05e5e615e6
AP: Skip authentication/deauthentication phase for DMG/IEEE 802.11ad
|
8 years ago |
|
Dedy Lansky
|
0c4b9025c1
AP: Do not look for supported rates in DMG/IEEE 802.11ad
|
8 years ago |
 Beni Lev
|
e72faadb49
bgscan_simple: Fix short_scan_count comparison
|
8 years ago |
 Andrei Otcheretianski
|
517b5f928f
nl80211: Zero num_modes if nl80211_get_hw_feature_data() fails
|
8 years ago |
 Jouni Malinen
|
5e8f231947
tests: P2P autonomous GO switching channels (separate group interface)
|
8 years ago |
 Avraham Stern
|
4041d2af4d
tests: Use group control interface for GO commands in autogo_chan_switch
|
8 years ago |
 Kanchanapally, Vidyullatha
|
39c5da3284
nl80211: Use correct attribute for scan flags in vendor scan
|
8 years ago |
 Purushottam Kushwaha
|
c167662d73
eap_proxy: On SIM error flush PMKSAs only for SIM/AKA/AKA' networks
|
8 years ago |
|
Jouni Malinen
|
6c7a7c7996
tests: Beacon request - active scan mode and old scan result
|
8 years ago |
|
Jouni Malinen
|
28b32e66d8
tests: Beacon request - passive scan mode and no matching BSS
|
8 years ago |
|
Jouni Malinen
|
1edc31904a
tests: Beacon request - active scan mode and many BSSs
|
8 years ago |
|
Jouni Malinen
|
618073aa2e
tests: LCI report generation OOM
|
8 years ago |
|
Jouni Malinen
|
b157f0e265
tests: wpa_supplicant and concurrent NEIGHBOR_REP_REQUEST commands
|
8 years ago |
|
Jouni Malinen
|
b865987571
tests: NEIGHBOR_REP_REQUEST for AP not supporting neighbor report
|
8 years ago |
|
Jouni Malinen
|
fc22c9cfba
tests: wpa_supplicant and disconnection during NEIGHBOR_REP_REQUEST
|
8 years ago |
|
Jouni Malinen
|
1c2bfe9984
tests: wpa_supplicant ctrl_iface NEIGHBOR_REP_REQUEST OOM
|
8 years ago |
|
Jouni Malinen
|
6657bb158b
Fix OOM handling in neighbor report response handling
|
8 years ago |
|
Jouni Malinen
|
e24a155ee4
tests: wpa_supplicant behavior on NEIGHBOR_REP_REQUEST response timeout
|
8 years ago |
|
Jouni Malinen
|
eee09ebb4f
tests: Radio measurement request - protocol testing
|
8 years ago |
|
Jouni Malinen
|
7187e20930
Allow LCI request with no subelements
|
8 years ago |
|
Jouni Malinen
|
0f2e07cf47
tests: RRM beacon report with active and passive scan
|
8 years ago |
|
Jouni Malinen
|
d734201435
RRM: Enable beacon report with active/passive scan for all drivers
|
8 years ago |
|
Jouni Malinen
|
42b0982376
tests: Beacon request - beacon table mode
|
8 years ago |
|
Jouni Malinen
|
ec45927b8a
Report received beacon report with BEACON-RESP-RX event
|
8 years ago |
|
Jouni Malinen
|
f3383366aa
Report beacon request TX status as control interface event
|
8 years ago |
|
Jouni Malinen
|
90d9d7c32a
Beacon request through hostapd control interface
|
8 years ago |
|
Jouni Malinen
|
73a27a6345
Add hostapd configuration parameter rrm_beacon_report
|
8 years ago |
|
Jouni Malinen
|
de6ec8b558
Enable Beacon Report using beacon table for all drivers
|
8 years ago |
