brcmfmac43362-sdio.txt 1.0 KB

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051
  1. #AP6181_NVRAM_V1.1_01152013
  2. #adjuest PA parameter for g/n mode
  3. manfid=0x2d0
  4. prodid=0x492
  5. vendid=0x14e4
  6. devid=0x4343
  7. boardtype=0x0598
  8. # Board Revision is P307, same nvram file can be used for P304, P305, P306 and P307 as the tssi pa params used are same
  9. #Please force the automatic RX PER data to the respective board directory if not using P307 board, for e.g. for P305 boards force the data into the following directory /projects/BCM43362/a1_labdata/boardtests/results/sdg_rev0305
  10. boardrev=0x1307
  11. boardnum=777
  12. xtalfreq=26000
  13. boardflags=0xa00
  14. sromrev=3
  15. wl0id=0x431b
  16. macaddr=00:90:4c:07:71:12
  17. aa2g=1
  18. ag0=2
  19. maxp2ga0=74
  20. cck2gpo=0x2222
  21. ofdm2gpo=0x66666666
  22. mcs2gpo0=0x7777
  23. mcs2gpo1=0x7777
  24. pa0maxpwr=56
  25. #P207 PA params
  26. #pa0b0=5447
  27. #pa0b1=-658
  28. #pa0b2=-175<div></div>
  29. #Same PA params for P304,P305, P306, P307
  30. pa0b0=5447
  31. pa0b1=-607
  32. pa0b2=-160
  33. pa0itssit=62
  34. pa1itssit=62
  35. cckPwrOffset=5
  36. ccode=0
  37. rssismf2g=0xa
  38. rssismc2g=0x3
  39. rssisav2g=0x7
  40. triso2g=0
  41. noise_cal_enable_2g=0
  42. noise_cal_po_2g=0
  43. swctrlmap_2g=0x04040404,0x02020202,0x02020202,0x010101,0x1ff
  44. temp_add=29767
  45. temp_mult=425